With RealTestTM technology, the CO gas sensing cell used in the
CO1224T and CO1224TR CO detectors can be tested using a CO gas
agent, fully meeting the requirements of NFPA 720: 2009. Simply put
the detector into RealTest mode, spray a small amount of CO into
the detector per the installation instructions, and within seconds the
detector will alarm, indicating successful gas entry. (See the reverse
page or the user manual for complete instructions.)
When dangerous amounts of CO are detected, the CO1224T and
CO1224TR detectors alert residents by sounding and flashing a
temp 4 signal alarm. With 24/7 central station monitoring, residents
are guaranteed protection whether they are away from home,
sleeping, or already suffering from the effects of CO.
The CO1224T and CO1224TR are designed for system operation.
These detectors are fully listed to UL 2075 and offer a code-required
trouble relay to send a sensor failure or end-of-life signal to the
control panel and the central station. The CO1224T and CO1224TR
also use SEMS-type terminal Philips head screws for quicker
and more positive wiring connections and code-required wiring
supervision. With a low current draw, these detectors enable more
devices to be connected to the panel, limiting the need to purchase
extra power supplies or more expensive panels. As 12/24 VDC
detectors, the CO1224 will operate on most industry security and fire alarm control panels
- RealTest enables a functional test using canned CO
- Full compliance with UL 2075
- Wiring supervision with SEMS terminals
- 12/24 VDC
- Versatile mounting for wall and ceiling
No comments:
Post a Comment